Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Reset Tyre Pressure Sensor on Jeep Compass

Model: Jeep Compass 552, MK 2 - Years 2016-2025
Part:

The tyre pressure sensor is similar across all Jeep models. In this case, the example is from a Jeep Wrangler, but it is identical for other models, including the Compass. The tyre pressure sensor is yellow and usually located on the right; it indicates that there is an issue with the tyre pressure, as shown in the video. First, check the manual for the correct tyre pressure. Once done, you may need to drive the vehicle for up to 12 miles at a speed above 15 mph before the light turns off. If the light remains on, you likely have a faulty tyre pressure sensor. At this point, it is advisable to take it to any workshop equipped with the appropriate scanner to check if all five sensors are reading correctly. It is quite common for a sensor to become damaged or for a sensor battery to fail.

Updated on 10 March 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the TPMS Sensor and Turn Off the Tyre Pressure Warning Light on a Jeep Compass
Jeep Compass (2006-2016 / MK 1, MK 49) This guide shows how to replace traditional valves with those equipped with tyre pressure sensors on a Jeep Compass and turn off the corresponding wa…
Resetting the Tyre Pressure Warning Light on Jeep Compass
Resetting the Tyre Pressure Warning Light on Jeep Compass
Jeep Compass (2016-2025 / 552, MK 2) In this video, you can see how to reset the tyre pressure warning light on a Jeep Compass by following a few simple steps necessary for the proper fu…
How do you reset the tire pressure light in the Jeep Compass?
How do you reset the tire pressure light in the Jeep Compass?
Jeep Compass (2006-2016 / MK 1, MK 49) For greater clarity, it is important to specify that this video guide, as also highlighted by the protagonist, can be used for both the Jeep Renegade…

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos