Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Front Bumper from a Jeep Compass

Model: Jeep Compass MK 1, MK 49 - Years 2006-2016
Part: Front bumper

This guide shows how to remove the front bumper from a Jeep Compass. After securing the vehicle and opening the bonnet, you need to unscrew the five Torx T20 screws and the two 10 mm bolts located on the sides of the headlights. At this point, remove the screws in the wheel arch on both sides. Unscrew the bolts located at the bottom of the bumper and, with a bit of force, detach one side of the bumper while being careful of the electrical connections present. At this point, the removal of the front bumper is complete. Reassembly is done in the same way but in reverse order.

Updated on 23 April 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Front Headlight on a Jeep Compass
How to Replace the Front Headlight on a Jeep Compass
Jeep Compass (2006-2016 / MK 1, MK 49) Before starting, open the front bonnet of your Jeep Compass. Begin by disassembling and removing the front bumper by unscrewing the fastening screws …
Removing the Front Headlight of a Jeep Compass
Removing the Front Headlight of a Jeep Compass
Jeep Compass (2006-2016 / MK 1, MK 49) Below, we explain how to replace the front headlight of your Jeep Compass. First, you need to detach the front bumper by unscrewing the screws from t…
How to Remove the Front Headlamp of a Jeep Compass
How to Remove the Front Headlamp of a Jeep Compass
Jeep Compass (2016-2025 / 552, MK 2) Below are the instructions to remove and replace the front bumper and headlamp assembly of the Jeep Compass. First, you need to remove the front bump…

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos