Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Remote Control Battery on the Jeep Compass

Model: Jeep Compass MK 49, MK 1 - Years: 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016
Part: Key

See other generations:
Video tutorial

This video shows the procedure to follow for replacing the remote control battery. From the remote, extract a metal key from the bottom, behind which you will notice a latch.

Now, using a flathead screwdriver, press on the mentioned latch until the two parts of the remote disconnect. Inside, you will find the battery to be replaced, a lithium CR2032 model.

After removing the old battery, before installing the new one, check the condition of the clips that hold the battery in place, ensuring they are intact and respecting the + and - polarity. Finally, snap the two parts of the remote back together, and the procedure is complete.


Updated on 31 May 2026 by ScegliAuto


Related tutorials

How to access the Jeep Compass vehicle when the remote control battery is low?
How to access the Jeep Compass vehicle when the remote control battery is low?
Jeep Compass (2016-2025 / 552, MK 2) Today we will explain how to board the 2020 Jeep Compass when the remote control suddenly stops working. All new generation remote controls are equip…
How to Replace the Remote Battery on the Jeep Compass?
How to Replace the Remote Battery on the Jeep Compass?
Jeep Compass (2016-2025 / 552, MK 2) To replace the battery in the remote for the Jeep Compass, lift the lever located on the back of the remote to extract the key from the top. Once thi…
How to Replace the Key Battery of the Jeep Compass
How to Replace the Key Battery of the Jeep Compass
Jeep Compass (2016-2025 / 552, MK 2) Replacing the key battery of a Jeep Compass is a straightforward process that you can do yourself. First, remove the metal key stored inside the shel…

How to Remove the Rear Seat of a Hyundai Tucson?

To remove the rear seat of a Hyundai Tucson, follow these steps. Start by moving the front seats to their most forward position to gain space. Next, locate the release lever on the underside of the rear seat, near the floor. Press this lever down while pulling the seat upwards to unlock it from the anchor pins. Once unlocked, tilt the seat upwards and forwards to remove it from its position. Repeat this process for both sides of the rear seat. Be careful of any electrical cables or components that may be connected to the seat during removal. Once the rear seat is removed, the disassembly is complete.

Watch the video!


by ScegliAuto

More videos