Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Kia
    3. :
  3. Sorento
    4. : Replacement headlight bulbs on Kia Sorento

Kia Sorento - Video tutorial

Model: Kia Sorento MK 1 - Years 2002-2009
Part: Headlight bulb
Operation: Replacement headlight bulbs on Kia Sorento

Open the hood and put on the special support rod. Unscrew the three screws that secure the affected headlight to the rest of the frame: two are located towards the central area of the bumper, near the ventilation grille, one on the side of the bonnet. Disconnect the three connectors and place yourself on a workbench. Unscrew and remove the round cover on the back of the bulb to be replaced, then disconnect the cable and lift the small metal catch that holds the bulb in place. Insert the new bulb you purchased, reassemble the headlight and put it back on the car.


Posted on 9 January 2024 by ScegliAuto



How to replace the front headlight of the Kia Sorento.
Kia Sorento (2009-2014 / MK 2) Below we will see the instructions that will allow us to dismantle and replace the front headlight of the Kia Sorento, following these simple steps.
How to change Kia Sorento headlight bulbs
Kia Sorento (2002-2009 / MK 1) Do we want to replace the rear light of the Kia Sorento? We remove the rear light from inside its body. Lift the tailgate of the luggage compartment
How to replace the headlight bulbs on the Kia Sorento Mk1
Kia Sorento (2002-2009 / MK 1) The guide shows how to replace the headlight bulbs of the Kia Sorento Mk1. To perform this operation it is necessary to use a 10 mm socket wrench to

Other guides that may interest you

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos