Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to replace the rear light bulbs of the Lancia Ypsilon.

Model: Lancia Ypsilon MK 3, Y3, Ypsilon 3, 846 - Years 2011-2023
Part: Tail light bulb

In this guide, we will see the instructions that will allow us to disassemble and replace the bulbs of the rear light of the Lancia Ypsilon. First, let's open the rear trunk hatch and start unscrewing the two fastening screws located on the side of the light; disconnect the bulb's electrical connector to remove it, as shown in the video. At this point, let's separate the bulb holder from the light fixture, replacing any faulty stop bulbs with new ones; assemble the light and connect it, then check the functioning of the stop lights.

Posted on 1 January 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Rear Headlight Bulbs/LEDs on a Lancia Ypsilon
How to Replace the Rear Headlight Bulbs/LEDs on a Lancia Ypsilon
Lancia Ypsilon (2003-2011 / 843, MK 2, Ypsilon 2, Y2) Do you want to replace the rear headlight bulbs/LEDs on your Lancia Ypsilon but don't know how to proceed? Here's how to do it: open the boot and use…
Replacing the Headlight Bulbs on a Lancia Ypsilon
Replacing the Headlight Bulbs on a Lancia Ypsilon
Lancia Ypsilon (2003-2011 / 843, MK 2, Ypsilon 2, Y2) Replace the bulbs in the front headlight on a Lancia Ypsilon: open the bonnet by pulling the lever located at the bottom right of the dashboard, and …
How to Replace the Rear Headlight Bulb on a Lancia Ypsilon
How to Replace the Rear Headlight Bulb on a Lancia Ypsilon
Lancia Ypsilon (2003-2011 / 843, MK 2, Ypsilon 2, Y2) To replace the rear headlight bulb on a Lancia Ypsilon, open the tailgate and loosen the two fixing screws located immediately next to the light clus…

How to Repair the Key Spring of the Peugeot 207?

Over time, frequent use of the key's flip mechanism in the vehicle, dozens of times a day, inevitably leads to wear of the internal spring. As shown in this video, replacing the spring is quite simple and takes little time. After opening the casing halfway, first position the key, then the spring housing, and finally insert the spring into the previously mentioned housing. Close the casing by rotating it clockwise, ensuring all components fit perfectly, and test the key's flip mechanism.

Watch the video!


by ScegliAuto

More videos