Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to replace the tail lights on a Lincoln MKZ?

Model: Lincoln Mkz MK 2 - Years 2013-2020
Part: Tail light

In this tutorial, you will see how to replace the tail lights on a Lincoln MKZ, a very simple and quick operation. First, make sure the key is not in the ignition for safety. Then, open the trunk and remove the bottom panel. Once done, take off the inner plastic cover by removing each retaining clip, move the carpet located at the back of the tail light in question, and unscrew the three bolts with a 10mm wrench. At this point, disconnect the power connector, pull the tail light out of the body, and install the replacement.

Updated on 8 June 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Key Fob Battery for the Lincoln MKZ?
How to Replace the Key Fob Battery for the Lincoln MKZ?
Lincoln Mkz (2013-2020 / MK 2) To replace the key fob battery for the Lincoln MKZ, press the button located on the bottom of the device to extract the key inside the fob. After rem…
How to Replace the Air Filter on a Lincoln MKZ?
How to Replace the Air Filter on a Lincoln MKZ?
Lincoln Mkz (2013-2020 / MK 2) To replace the air filter on a Lincoln MKZ, open the hood to access the components inside the engine compartment. The box containing the filter is lo…
How to Replace the Rear Headlight Bulb in a Lincoln MKZ?
How to Replace the Rear Headlight Bulb in a Lincoln MKZ?
Lincoln Mkz (2006-2012 / MK 1) To replace the rear headlight bulb in a Lincoln MKZ, open the trunk lid so you can detach the clips that secure the carpet inside the trunk. Once thi…

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos