Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Mazda MX-5 clutch pump replacement

Model: Mazda Mx 5 NC, MK 3 - Years 2005-2015

In this video we will see how to replace the Mazda MX-5 clutch master cylinder. First we go to open the bonnet of our car and we go to disassemble the pump which is next to the power steering fluid (immediately near the body on the right side): we take a 10 mm wrench and we go to disassemble the slave connection of the pump. Now with a 12 mm wrench we are going to disassemble the bolt that holds the pump itself to the engine compartment: also have the socket wrench to be able to unscrew the nuts. Once done we can complete the clutch pump removal procedure.

Posted on 26 June 2020 by ScegliAuto

Video tutorial

Related tutorials

Timing Belt Replacement
Timing Belt Replacement
Mazda Mx 5 (1998-2005 / NB, MK 2) It is recommended to perform this maintenance only if you have good general mechanical knowledge, as a simple error in positioning the belt could sev…
Battery replacement for Mazda MX-5
Battery replacement for Mazda MX-5
Mazda Mx 5 (1998-2005 / NB, MK 2) .. us to disassemble and replace the battery of the Mazda MX-5, in simple and quick steps. First, we open the rear hatch of the car and locate the battery,.. …
How do i replace the Mazda MX-5 remote control battery?
How do i replace the Mazda MX-5 remote control battery?
Mazda Mx 5 (2015-2024 / ND, MK 4) .. In order to replace the Mazda MX-5 remote control battery, you need to lower the lever located on the back of the remote control,.. …

Other guides you may be interested in

How to Change the Diesel Filter on a Renault Captur 1.5 dCi

The diesel filter on the Renault Captur is always of the immersion type, but instead of being located at the top of the engine bay, it is positioned lower, inside the front right wheel arch (passenger side), practically under the headlamp. To replace it, it is advisable to lift the vehicle, remove the front right wheel and the corresponding inner lining to access the filter location. Unscrew the fastening nuts of the support clamp to extract it from its housing and disconnect the connector and pipes. At this point, unscrew the fixing screws of the cap, remove the old filter and insert the new one, also replacing the O-ring seals, and then reverse the steps for installation. Before starting the engine, turn the ignition on and off several times to allow the filter to fill.

Watch the video!


by ScegliAuto

More videos