Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Front Shock Absorber Replacement

Model: Mazda 3 BK, MK 1 - Years: 2003, 2004, 2005, 2006, 2007, 2008, 2009
Part: Shocks

See other generations:
Video tutorial

Loosen the wheel nuts and lift the vehicle, securing it safely. Unscrew the bolts and remove the wheel.

Unscrew and extract the retaining pins from the suspension arm using a 16 mm spanner and push them out. Use penetrating spray to ease the operation. Also disconnect the steering tie rod. Using a socket and ratchet, remove the suspension bolts and detach the shock absorber.

Remove the protective cover in the engine bay by unscrewing the three bolts at the top of the suspension with a 16 mm spanner, and perform the same operation on the other shock absorber after removing the expansion tank. Remove the entire suspension assembly and clean off any deposits with a wire brush.

Use the appropriate equipment to compress the spring to allow the removal of the old shock absorber and replace it with a new one. Also replace the spring and rubber gaiter. Refit the suspension to the vehicle in reverse order.


Updated on 7 February 2026 by ScegliAuto


Related tutorials

Front Shock Absorber and Link Replacement
Front Shock Absorber and Link Replacement
Mazda 3 (2003-2009 / BK, MK 1) Lift the vehicle on suitable axle stands, remove the front wheel; disconnect the speed sensor and the brake fluid pipe from the shock absorber suppor…
Front Shock Absorber Replacement
Front Shock Absorber Replacement
Mazda 3 (2003-2009 / BK, MK 1) Lift the vehicle on suitable axle stands, remove the front wheel, and pre-lubricate the bolts to be removed with penetrating spray. Proceed to remove…
Front Shock Absorber Replacement
Front Shock Absorber Replacement
Mazda 3 (2003-2009 / BK, MK 1) To replace the front shock absorbers, first obtain the appropriate clamps to compress the spring and then remove the support from the shaft; start by…

How to Reset the Tyre Pressure Warning Light on a Kia Rio?

The tyre pressure warning light displayed on the instrument cluster of the Kia Rio can be reset by inflating the tyres until they reach the recommended pressure value: this value is indicated on the sticker affixed to the driver's door pillar. Once all tyres have been inflated to the recommended pressure, turn on the ignition to check that the light has disappeared: if it is still present, it may be necessary to drive for a few miles, allowing the sensors to work and thus turning off the light.

Watch the video!


by ScegliAuto

More videos