Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacement of Front Shock Absorber

Model: Mazda 3 BK, MK 1 - Years: 2003, 2004, 2005, 2006, 2007, 2008, 2009
Part: Shocks

See other generations:
This video is currently unavailable

Loosen the wheel nuts and lift the vehicle securely. Remove the wheel by unscrewing the bolts.

Unscrew and extract the retaining pins from the suspension arm using a 16mm spanner and push them out. Use penetrating spray to ease the operation. Also disconnect the steering tie rod. Using a fixed spanner and a ratchet, remove the suspension bolts and detach the shock absorber.

Remove the protective cover in the engine bay with a 16mm spanner, unscrewing the three bolts at the top of the suspension, and perform the same operation on the other shock absorber after removing the expansion tank. Remove the entire suspension assembly and clean off any debris with a wire brush.

Use the appropriate equipment to compress the spring to allow for the extraction of the worn shock absorber and replace it with a new one. Also replace the spring and rubber boot. Refit the suspension onto the vehicle in reverse order.


Updated on 8 February 2026 by ScegliAuto


Related tutorials

Front Shock Absorber and Link Replacement
Front Shock Absorber and Link Replacement
Mazda 3 (2003-2009 / BK, MK 1) Lift the vehicle on suitable axle stands, remove the front wheel; disconnect the speed sensor and the brake fluid pipe from the shock absorber suppor…
Front Shock Absorber Replacement
Front Shock Absorber Replacement
Mazda 3 (2003-2009 / BK, MK 1) Lift the vehicle on suitable axle stands, remove the front wheel, and pre-lubricate the bolts to be removed with penetrating spray. Proceed to remove…
Front Shock Absorber Replacement
Front Shock Absorber Replacement
Mazda 3 (2003-2009 / BK, MK 1) To replace the front shock absorbers, first obtain the appropriate clamps to compress the spring and then remove the support from the shaft; start by…

How to Open the Fuel Filler Flap in the Hyundai i30?

In this tutorial, you will learn how to open the fuel filler flap in the Hyundai i30, a very simple operation that follows the typical procedure of most vehicles. First, unlock the locks using the designated button on the remote, then open the driver's door, locate the release lever on the left side of the seat, and operate it. Next, move to the fuel filler flap, open it completely, unscrew the cap, and refuel as needed. To close the flap, simply press it gently.

Watch the video!


by ScegliAuto

More videos