Do it yourself
Frequently asked questions about cars and motorcycles

How to Reset the DPF Light on a Mazda 6 MK2

Model: Mazda 6 GH, MK 2 - Years 2008-2012
Part: Warning light – error code

In this video tutorial, you will learn how to reset the diesel particulate filter (DPF) light on the second generation Mazda 6. First, open the bonnet of your car and start by removing the plastic cover of the fuse box, located to the right of the battery. Next, connect a copper wire to the connector found at the top left, as shown in the video. At this point, ground the other end of the wire. Then, press the accelerator pedal ten times to perform the reset.

Updated on 31 May 2026 by ScegliAuto

Video tutorial

Related tutorials

Mazda 6 (2002-2008 / GG, MK 1) In this video tutorial, learn how to reset the DPF (Diesel Particulate Filter) warning light on a Mazda 6, following the steps outlined below. First,…
Mazda 6 (2012-2024 / GJ, MK 3) To reset the DPF light on a Mazda 6, go inside the cabin and turn on the instrument panel. Once this is done, ensure that all diagnostic cables are c…
Mazda 6 (2008-2012 / GH, MK 2) Today we will see how to reset the DPF light on a Mazda 6, model produced from 2008 to 2012. Let's start by opening the hood and the fuse box located…

Other guides you may be interested in

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos