Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Mercedes
    3. :
  3. Classe A
    4. : How to replace the crankshaft rpm sensor on Mercedes Casse A

Mercedes Classe A - Video tutorial

Model: Mercedes Classe A W169 - Years 2004-2012
Part: Crankshaft RPM sensor
Operation: How to replace the crankshaft rpm sensor on Mercedes Casse A

Let's see in this video how to replace the crankshaft rpm sensor on Mercedes A cases: we raise the front engine hood, we secure the same with the holding rod. We identify the crankshaft rpm sensor, with a socket wrench we can unscrew the locking pins (if present next to the valve). We detach the piece from the motor seat. We compare the worn piece with the new one, mount the piece with the respective clamping pins, connect the crankshaft rpm sensor. Finally, we check the maintenance carried out and the correct functioning of the vehicle.


Posted on 16 October 2023 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • Classe A 2018-2024 - Where is the speed sensor of the Mercedes Benz A-Class 180 located? Read Answer
    • Classe A 2012-2018 - Where is the engine speed sensor of a Mercedes A-Class located? Read Answer
    • Classe A 2004-2012 - How much does the Mercedes A-Class crankshaft sensor cost? Read Answer
    • Classe A 2012-2018 - How much is the engine speed sensor of the Mercedes A-Class 180 diesel? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos