Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Mercedes
    3. :
  3. CLA
    4. : How to straighten a car door without repainting

Mercedes CLA - Video tutorial

Model: Mercedes CLA X117, C117 - Years 2013-2019
Part: Door
Operation: How to straighten a car door without repainting

If contact with another vehicle has caused a door panel to retract completely with the luck that there have been scratches or damage to the paint, one solution is to try to straighten the panel by pulling it with a suction cup rather than pushing it from the inside. removing the door panel; in this regard there is a special tool, a sliding hammer with a suction cup in one point: clean the surface of the door, vaporize some water so as to make the suction cup adhere perfectly and pull the slider back in order to give a blow dry, repeating the operation until the panel comes out completely.


Posted on 13 December 2023 by ScegliAuto

This video is currently unavailable


What to do in case of a fuel door lock in a Mercedes CLA?
Mercedes CLA (2013-2019 / X117, C117) In the Mercedes CLA, it can happen that the fuel door remains locked, for example due to a malfunction in the actuator or the control button. In any
How to install Mercedes logo projectors in the door of the CLA
Mercedes CLA (2013-2019 / X117, C117) In this video we see how to easily install the door logo projectors on the Mercedes CLA. However, we were not able to find the projectors suggested b
How to remove the door panel on Mercedes Classe Cla
Mercedes CLA (2013-2019 / X117, C117) Let's see how to remove the door panel of a Mercedes Cla-Class? Before starting the disassembly work, let's disconnect the battery terminals in the l

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos