Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. MG
    3. :
  3. ZS
    4. : How to replace the rear wheel bearing of the MG ZS

MG ZS - Video tutorial

Model: MG ZS Zs11 - Years 2017-2024
Part: Bearing
Operation: How to replace the rear wheel bearing of the MG ZS

Let's see in this short and simple guide how to disassemble and replace the rear wheel bearing of the MG ZS, following the instructions below. First of all we raise the car on the rear side, lifting the wheel off the ground, and we begin to disassemble the rear wheel; then we go to unscrew the screws of the brake caliper, removing it from the disc, as shown in the video. At this point we unscrew the central nut of the bearing to remove it, therefore replacing it with the new one; let's insert it until it reaches the stop, then reassemble the brake caliper, following the video tutorial to the end!


Posted on 11 August 2022 by ScegliAuto



How do i replace the handbrake caliper on the MG ZS?
MG ZS (2017-2024 / Zs11) In order to replace the handbrake caliper of the MG ZS you have to go and lift the machine, so that you can loosen the bolts that fix the rear right
How to change the wheel with the spare wheel of the MG ZS
MG ZS (2017-2024 / Zs11) In this guide, we see the step-by-step instructions to remove and replace the MG ZS spare wheel with the spare, in simple and quick steps. First we o
How do you install the rear camera of the MG ZS?
MG ZS (2017-2024 / Zs11) In order to install the rear camera of the MG ZS, you need to use an object to pry off the inner cover of the rear hatch: underneath it, you will be

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos