|
Do it yourself
| |||
| ||||
How to Replace the Oil Filter and Engine Oil in a Nissan Armada
Model: Nissan Armada
Ta60
- Years 2004-2015
To perform this job, you will need: seven quarts of oil (SAE 5W-30), an oil filter (3323) by BOSCH, a 3/8 ratchet, a couple of three-inch extensions, a six-inch extension, a 14 mm socket, a 10 mm socket, and a special tool to remove the filter. Remove the oil cap to facilitate draining the oil; lift the vehicle with a jack or place it in a pit. Once the vehicle is raised, remove the skid plate by unscrewing the bolts using the 10 mm socket. After removing the skid plate, you can unscrew the oil filter with the special tool. Place a container underneath to catch the oil that spills out and remove the filter. Lubricate the o-ring of the new oil filter and screw it in place (first by hand and then with the filter wrench). Position a container for collecting the used oil and unscrew the oil drain plug, then wait for all the oil to drain. Place a new gasket on the drain plug and screw it in place without over-tightening. Reinstall the skid plate, lower the vehicle, and top off with new engine oil. Using a funnel, initially add about 5 quarts of oil, then start the engine for about 5 minutes to circulate the oil in the engine system, and then add the remaining oil (check the level with the dipstick).
Updated on 8 August 2026 by ScegliAuto
Video tutorial
Related tutorials
Nissan Armada
(2017-2024 /
Y62)
Replacing the cabin filter in a Nissan Armada is a simple and quick task. Here's how to proceed in this tutorial. You will only need a T20 Torx wrenc…
Nissan Armada
(2017-2024 /
Y62)
This video tutorial shows how to reset the maintenance light on a 2020 Nissan Armada. The procedure is very simple. First, get inside the vehicle and…
Nissan Armada
(2004-2015 /
Ta60)
This guide shows how to replace the fuel filter on the Nissan Armada TA60. The first step is to open the hood and secure the vehicle. At this point, …
Other guides you may be interested in
|
How to Open a Stuck Boot on the Peugeot 407?
On the Peugeot 407, the boot may become stuck, possibly due to a problem with the control button or the lock actuator. In such cases, you can perform an emergency opening by following the simple procedure shown in this tutorial. First, open the rear doors, then lower the seat back by operating the release lever. Next, go inside the boot, locate the lock, and manually operate it using a flathead screwdriver. The boot will then be free to open. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.424
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |