Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Vauxhall
    3. :
  3. Astra
    4. : Opel Astra H 1.7 CDTI turbine disassembly instructions

Vauxhall Astra - Video tutorial

Model: Vauxhall Astra Astra H - Years 2004-2010
Part: Turbine
Operation: Opel Astra H 1.7 CDTI turbine disassembly instructions

In today's video tutorial we will see instructions on how to disassemble the turbine on an Opel Astra H 1.7 CDTI. We open the bonnet of our car and first of all we go to remove the engine protection; after which we remove and disconnect the air intake sleeve from our turbine by unscrewing the clamp screw. At this point we remove the oil pump screws and drain the engine oil, unscrewing the oil vent bolt: now we unscrew the exhaust manifold screws and extract all the gas recovery system, together to the turbine!


Posted on 5 January 2024 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • Astra 2015-2022 - What is the cost to replace the turbocharger in the Opel Astra 1.7 CDTi? Read Answer
    • Astra 2004-2010 - How much does it cost to replace the turbine in the Opel Astra 1.7 CDTi? Read Answer
    • Astra 2009-2016 - How to recognize problems with the turbine of the Opel Astra 1.7 CDTI? Read Answer
    • Astra 2009-2016 - Where is the turbine located in the Opel Astra? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos