Do it yourself
Frequently asked questions about cars and motorcycles
  1. Car
  2. :
  3. Vauxhall
  4. :
  5. Meriva
  6. : Disassembly of the alternator on Opel Meriva A Ecotec

Vauxhall Meriva - Video tutorial

Model: Vauxhall Meriva MK 1, Meriva A - Years 2003-2010
Part: Alternator
Operation: Disassembly of the alternator on Opel Meriva A Ecotec

In this video tutorial we will see how to remove and replace the starter motor on an Opel Meriva A Ecotec, first series. First of all we open the bonnet and go to disconnect and remove the air filter box, removing the intake sleeve and unscrewing the cover screw; once the filter box has been removed, we access the alternator, which we find immediately below. At this point, let's first disconnect the negative pole of the battery and start by removing the alternator fixing bolts; we just have to remove the V-belt to remove it, following the video to the end!


Posted on 27 January 2024 by ScegliAuto



How to replace a Meriva alternator 1.7
Vauxhall Meriva (2003-2010 / MK 1, Meriva A) Let's see how to replace the alternator of an Opel Meriva. The first thing we need to do is lift the front hood of the engine, then stop it with the
Replacing the alternator on Opel Meriva
Vauxhall Meriva (2003-2010 / MK 1, Meriva A) Replacing the alternator on an Opel Meriva, let's see how it is removed from inside the engine compartment. We lift the bonnet putting it in safety,
Disassembly of the alternator on Opel Meriva
Vauxhall Meriva (2010-2017 / Meriva B, MK 2) Jack up the car and remove the left rear wheel. Disconnect the battery (both poles) and remove the 8 nut of the alternator that fixes the blue cable,

Other guides that may interest you

    Frequently Asked Questions

    • Meriva 2010-2017 - How to recognize an alternator problem in the Opel Meriva? Read Answer
    • Meriva 2003-2010 - What is the problem with the Opel Meriva alternator? Read Answer
    • Meriva 2003-2010 - Where is the Opel Meriva 1.7 alternator located? Read Answer

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos