Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Peugeot
    3. :
  3. 2008
    4. : How to replace the air cabin filter pollen on the Peugeot 2008

Peugeot 2008 - Video tutorial

Model: Peugeot 2008 MK 1 - Years 2013-2019
Part: Cabin air filter
Operation: How to replace the air cabin filter pollen on the Peugeot 2008

To replace the passenger compartment air filter of the Peugeot 2008 climate control we must open the front hood of the engine compartment. We identify the position of the air filter which, in this case, is placed under the grille which is immediately next to the windshield on the left side (as shown by the red arrows in the images). Remove the plastic grid by acting on the three clips (indicated by the red arrows) that hold it in place. Thus, we have access to the small filter and the largest filter that we can extract after pressing the sides of the same. First we take out the filter and then the bigger filter. This should be done every 15,000 km or at least once a year.


Posted on 25 October 2023 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • Peugeot 2008 2019-2026 - Where is the cabin air filter located in the Peugeot 2008? Read Answer
    • Peugeot 2008 2013-2019 - Where is the pollen filter located on Peugeot 2008? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos