Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Peugeot
    3. :
  3. 2008
    4. : How to remove the engine air filter of a Peugeot 2008

Peugeot 2008 - Video tutorial

Model: Peugeot 2008 MK 1 - Years 2013-2019
Part: Oil filter
Operation: How to remove the engine air filter of a Peugeot 2008

Let's see how to remove the engine air filter of a Peugeot 2008. We open the car door, pull up the engine compartment opening lever located at the bottom left of the dashboard and lift up the front hood, we secure the same with the auction. Remove the engine soundproofing panel, then open the air kit (unscrew the tightening screws with a special key), uncover the filter box cap and extract the worn air filter. We insert a new filter in the dedicated housing (making it adhere well around the walls). Finally we reassemble the cap of the air box and tighten the screws. We close the front hood at the end of the assembly.


Posted on 14 November 2023 by ScegliAuto

This video is currently unavailable

Other guides that may interest you

    Frequently Asked Questions

    • Peugeot 2008 2019-2026 - When should the oil filter in the Peugeot 2008 be replaced? Read Answer
    • Peugeot 2008 2013-2019 - Where is the Peugeot 2008 oil filter located? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos