|
Do it yourself
| |||
| ||||
Peugeot 3008 - Video tutorial
Model: Peugeot 3008
MK 2, P84
- Years 2016-2023 The guide shows how to change the oil in the Peugeot 3008 automatic transmission. The procedure must be carried out both from the engine compartment and from the bottom of the vehicle, therefore a vehicle lift must be used. From the bonnet, the engine air filter and its sleeve must be removed; this operation highlights, on the bottom of the vehicle, a colored Torx55 cap: it is the cap of the gearbox oil tank. Once the car has been lifted, unscrew the tank drain plug, located near the beginning of the exhaust pipe and before the front axle. With a Torx40 wrench you screw the first bolt, paying attention to have positioned a container under the tank and to the temperature of the oil. With a 17mm hex wrench the second stage of the drain plug is unscrewed; while the tank is completely empty, it is advisable to clean the two caps unscrewed just before. Put them back in place and tighten them well; lower the vehicle again. Using a funnel, pour in the new gear oil (the specifications are defined in the use and maintenance manual); the quantity is about 3 liters. Close the tank with the colored cap and refit the air filter.
Posted on 14 February 2024 by ScegliAuto
Other guides that may interest you
|
Frequently Asked QuestionsHow to reset the TPMS light of the Volkswagen Polo 2011
The orange tire light indicates the presence of one or more tires with an inflation pressure below the recommended limit. All this is easily solved by inflating them correctly or replacing them in the event of a puncture. After carrying out these operations it is necessary to reset the warning light and therefore also the sensor in order to have new reading data. All you have to do is start the car ignition and then fully open the glove compartment on the passenger side. Locate the two buttons in the right corner and press "Set". At this point the reset is complete and you can turn off the ignition. by ScegliAuto More videos
|