Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Porsche
    3. :
  3. Boxster
    4. : Suspension swing arm replacement

Porsche Boxster - Video tutorial

Model: Porsche Boxster 986, MK 1 - Years 1996-2004
Part: Arm
Operation: Suspension swing arm replacement

The oscillating arm of the rear suspension consists of a bush with silent block fixed by a pin to the rear axle, while on the other end there is a spherical head fixed to the hub support; to carry out the replacement, therefore, lift the car on special car stands, inserting two also under the bridge in order to support the suspension; in reality it could also be avoided to disassemble the wheel in any case disassemble the rear pin and then the head fixing nut then using the fork extractor for removal; we will then proceed backwards to install the new one.


Posted on 8 September 2023 by ScegliAuto



Replacement of the front headlight bulb of the Porsche Boxster.
Porsche Boxster (1996-2004 / 986, MK 1) Today's brief instructions will show us how to disassemble and replace the headlight bulb of the Porsche Boxster in simple steps. First, we open the
Engine air filter replacement
Porsche Boxster (1996-2004 / 986, MK 1) Replacing this filter is very simple and should be done often to keep the engine efficient. Open the bonnet and release the engine from the protectio
Porsche Boxster fuel pump replacement
Porsche Boxster (1996-2004 / 986, MK 1) Today we will see, in this video tutorial, how to disassemble and replace the fuel pump of a 1998 Porsche Boxster first series. First of all, we acce

How do you replace the horn on the Citroà «n Berlingo?

In order to replace the horn on the Citroà «n Berlingo, the vehicle must be raised so that the screws that secure the left front wheel can be loosened and removed completely. Once this wheel has been removed, it will be possible to access the screws that secure the internal cover of the corresponding wheel arch: this will have to be detached and it will be possible to access the components inside, including the horn. This will need to be disconnected from its connector and removed from its holders, so that it can be replaced with a new spare part.

Watch the video!


by ScegliAuto

More videos