Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. RAM
    3. :
  3. 2500
    4. : How to change the engine oil and its filter on the Dodge RAM 2500 Mk4

RAM 2500 - Video tutorial

Model: RAM 2500 MK 4, D2, DJ, DS - Years 2009-2019
Part: Engine oil
Operation: How to change the engine oil and its filter on the Dodge RAM 2500 Mk4

The guide shows you how to change the oil on the Dodge RAM 2500 Mk4. To carry out this operation it is necessary to empty the engine oil tank with a square wrench; during this operation, arrange a container for the used lubricating fluid. From the right front wheel compartment, using a wrench to remove the filters, it is possible to loosen the piece and extract it; it is advisable to buy a filter cap so that the oil does not leak during removal. Close the engine oil tank and clean up any residues. Fill the new oil filter with new lubricant and fit the closing cap; tighten it in place. Fill the tank with new engine oil and start the engine for a few minutes. Check the fluid level and top up if necessary.


Posted on 14 July 2022 by ScegliAuto



How to change the oil on Dodge Ram 6.7 Diesel
RAM 2500 (2009-2019 / MK 4, D2, DJ, DS) In this video tutorial we will see how to change the oil on a Dodge Ram 2500 6.7 liter Diesel engine. First we have to go under the vehicle and place
How do you replace the air filter on a Dodge Ram 2500?
RAM 2500 (2009-2019 / MK 4, D2, DJ, DS) In order to replace the air filter on the Dodge Ram 2500, you need to open the hood by locating the box that contains the filter, located on the left
How to reset the oil warning light on the Dodge RAM 2500
RAM 2500 (2019-2024 / DT, MK 5) Manually resetting the Dodge RAM 2500 engine oil change light is really very simple and the whole procedure takes a few seconds to complete even if y

Other guides that may interest you

How do I replace the Land Rover Evoque auxiliary battery?

In order to replace the auxiliary battery of the Land Rover Evoque, it is necessary to go inside the passenger compartment and remove the panel which is positioned immediately under the glovebox. Once the screws that secure this panel have been loosened, it will be possible to access the components located in its rear part, including the auxiliary battery. The latter must be disconnected from its cables and the fixing screws must be loosened. The battery can then be replaced with a new one and the panel can be fixed again with its screws.

Watch the video!


by ScegliAuto

More videos