|
Do it yourself
| |||
| ||||
How to change the diesel filter on a Renault Trafic II
Model: Renault Trafic
MK 2
- Years 2001-2014
In this video we will see how to change the diesel filter on a Renault Trafic II: the filter is located under the hood, on the left side of the engine (driver's side). It is a black plastic cylinder with an electrical connector on top and diesel pipes. To prevent air from entering the system, it is essential not to immediately unscrew the filter, but to prepare the system by emptying the bleed valve located on top of the filter: press it several times until the pressure becomes hard, pressurizing the system and pushing the diesel into the filter. Even if the filter is in the engine compartment, it may not be in a convenient position; lifting the car a bit will give us more space to work. Place a container under the filter, disconnect the electrical connector and unscrew the cartridge, allowing all the diesel to drain. Take the new filter, fill the cartridge with clean diesel (to reduce the possibility of air entering the system) and lubricate the o-ring with some new diesel. Screw the filter into its housing and tighten it without over-tightening. Bleed the air again as we did at the beginning and check for leaks at the connections. Reconnect the electrical connector, turn the key on and off 2 or 3 times, then start the engine: let it idle for a couple of minutes.
Posted on 10 September 2025 by ScegliAuto
Video tutorial
Related tutorials
Renault Trafic
(2014-2026 /
MK 3)
In this video, we will see how to change the diesel filter of the Renault Trafic: we open the hood and equip ourselves with a T30 hex key; the filter…
Renault Trafic
(2001-2014 /
MK 2)
In this video, we see how to change the diesel filter on the Renault Trafic II: inside on the left, we find it, and to remove it, we disconnect the e…
Renault Trafic
(2001-2014 /
MK 2)
The steps to replace the diesel filter of the Renault Trafic model 2 are not very complex to do independently. Let's start by dismantling the filter …
Other guides you may be interested in
|
How to reset the tyre pressure warning light on the Suzuki Jimny?
To reset the tyre pressure warning light on the Suzuki Jimny, first inflate the tyres to the pressure value indicated on the corresponding sticker: this is located at the bottom of the driver's door pillar. Once the tyres are inflated, insert the ignition key and turn on the instrument panel: select the screen that indicates the tyre pressures, checking that the values change. After a few seconds, the tyre pressure warning light will automatically turn off. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.720
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |