Do it yourself
Frequently asked questions about cars and motorcycles

Checking Fluid Levels on a Renault Trafic III 1.6 dCi

Model: Renault Trafic MK 3 - Years 2014-2026
Part: Checks and maintenance

In this video, you will see how to check the fluid levels on a Renault Trafic III 1.6 dCi. As described in the video, you will need: engine oil, brake fluid, coolant, and screenwash. Start by checking the oil level by pulling out the dipstick. Clean it and then reinsert it: the level should be below the "max" line; if it is lower, add oil according to the manufacturer's specifications, ensuring it never exceeds the maximum level. Also, check the coolant level, which can be seen from the semi-transparent reservoir. It should be between "min" and "max". If it is low, add more fluid of the same colour as that in the reservoir. Brake fluid theoretically does not get consumed; if the level has dropped, it means the pads are worn. Add some fluid but plan a visit to the mechanic. Finally, top up the fluid in the screenwash reservoir. Again, add its specific fluid, never tap water, which could damage the pipes and nozzles, as well as dirty the glass with limescale.

Posted on 3 April 2026 by ScegliAuto

Video tutorial

Related tutorials

Renault Trafic (2001-2014 / MK 2) Let’s go through the steps to remove and replace the starter motor in a Renault Trafic 2.5 DCI, following the instructions below. First, open the bon…
Renault Trafic (2001-2014 / MK 2) In this tutorial video, you will find the instructions to reset the service light for the regular maintenance oil change on a first series Renault Tr…
Renault Trafic (2001-2014 / MK 2) Today’s main instructions will allow us to remove and replace the timing belt on a Renault Trafic 1.9 dCi. In this specific case, the engine is remov…

Other guides you may be interested in

    Frequently Asked Questions

    • Trafic 2014-2027 - Where is the inertia switch located in the Renault Trafic van? Read answer
    • Trafic 2014-2027 - Why does the Start and Stop of a Renault Trafic not work? Read answer

How to Replace the Diesel Filter of the Peugeot 3008 1.5 BlueHDI

Briefly, we will see the main instructions for dismantling and replacing the diesel filter of the Peugeot 3008 1.5 BlueHDI. First, locate the diesel filter under the vehicle, so it will be necessary to lift it; then disconnect the electrical connector and the fuel lines from the filter, unscrewing the side screws to remove the cartridge, as shown in the video. At this point, replace the diesel filter with the new one, as well as with the original one; then reconnect the pipes and the electrical connector, following the video tutorial to the end!

Watch the video!


by ScegliAuto

More videos