|
Do it yourself
| |||
| ||||
Replacing Front Brake Pads
Model: Renault Laguna
MK 2, Laguna 2, X74
- Years 2001-2007
Loosen the wheel nuts and lift the vehicle, securing it with appropriate axle stands. Unscrew the bolts and remove the wheel. Using a screwdriver and hammer, push out the two clips of the brake shoe spring. Check the brake fluid level and ensure it is not at maximum. Using a plastic tool, remove the brake pads from their housing. Install the new pads, paying attention to the rotation direction stamped on the body. Before removing the inner pad, disconnect the electrical contact via its connector. Remove the second pad and install the new one, reconnecting the wires. Refit the spring and the two clips. Refit the wheel. Recheck the brake fluid level. Reset the position of the pistons by pressing the brake pedal.
Updated on 7 February 2026 by ScegliAuto
Video tutorial
Related tutorials
Renault Laguna
(2001-2007 /
MK 2, Laguna 2, X74)
When the brakes wear down, the oil level in the reservoir drops as the caliper pistons are nearly at their limit. To replace the pads and discs, lift…
Renault Laguna
(2007-2015 /
MK 3, Laguna III, MK III, X91, Laguna 3)
To replace the rear discs and pads (when replacing the discs, always replace the pads), lift the vehicle on a ramp and remove the rear wheel; remove …
Renault Laguna
(2007-2015 /
MK 3, Laguna III, MK III, X91, Laguna 3)
Periodically replace the engine air filter to enhance performance and fuel efficiency, ensuring the engine receives the correct amount of air. The ai…
Other guides you may be interested in
|
How to Replace the Diesel Filter of the Peugeot 3008 1.5 BlueHDI
Briefly, we will see the main instructions for dismantling and replacing the diesel filter of the Peugeot 3008 1.5 BlueHDI. First, locate the diesel filter under the vehicle, so it will be necessary to lift it; then disconnect the electrical connector and the fuel lines from the filter, unscrewing the side screws to remove the cartridge, as shown in the video. At this point, replace the diesel filter with the new one, as well as with the original one; then reconnect the pipes and the electrical connector, following the video tutorial to the end! by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.292
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |