|
Do it yourself
| |||
| ||||
How to Replace the Timing Belt on the Renault Scenic?
Model: Renault Megane
Megane III, Megane 3
- Years 2008-2015
To replace the timing belt on this model, refer to the following description and especially watch the video. First, open the bonnet and disconnect the battery, then lift the car and remove the right wheel, followed by removing the screws securing the inner wing. Next, remove the auxiliary belt by loosening the tensioner. Remove the lower soundproofing panel and the bolt securing the lower engine mount. Loosen the hose clamp on the coolant pipe under the radiator and drain the system. Once the upper engine mount is removed, you can use a small crane to lift it. Then, remove the upper timing belt cover and unscrew the screws holding the lower cover. At this point, you will have access to the belt and can insert the timing pin into the crankshaft and camshaft pulleys. Next, remove the crankshaft pulley and loosen the belt tensioner. Finally, you will be able to slide off the belt.
Updated on 7 July 2026 by ScegliAuto
Video tutorial
Related tutorials
Renault Megane
(2015-2023 /
Megane 4, Megane IV)
The timing belt on your Renault Megane with a 1.5 dCi engine should be replaced every 6 years or 160,000 miles. This varies significantly based on ve…
Renault Megane
(2002-2010 /
Megane 2)
In this guide, we will discover how to dismantle and replace the timing belt and water pump on the Renault Megane 1.5 dCi. First, lift the vehicle an…
Renault Megane
(2002-2010 /
Megane 2)
In this guide, we will go through the main steps to change the timing belt on a Renault Megane second series with a 1.5 DCI engine. First, lift the v…
Other guides you may be interested in
|
Frequently Asked QuestionsWhere is the Fuel Filter Located in a Volvo XC60?
In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.235
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |
