Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Install the Washer Fluid Level Sensor on the Renault Megane

Model: Renault Megane Megane IV, Megane 4 - Years: 2015, 2016, 2017, 2018, 2019, 2020, 2021, 2022, 2023
Part: Checks and maintenance

See other generations:
Video tutorial

This video shows how to install a sensor for detecting low washer fluid on the Renault Megane. Before installation, check if the vehicle is equipped for this use: there should be a red wire and a brown one. This procedure also applies to Talisman, Scenic, Espace, and Kadjar.

The device can be found on eBay with code 304950309771 for £19.27 plus £4.90 shipping. You can access it from the passenger side by removing the wheel, but removing the bumper makes the job easier.

Just remove the three screws underneath, then the four on top. The rest is clipped in. You will need to remove the wheel arch liners, and there is a screw on each side holding the bumper. Locate the tank where there is a connector underneath, disconnect it as this is where you will attach your sensor.

Empty the washer fluid as you will need to drill a hole to introduce your sensor. Place the gasket and clip the sensor in. Once you have reassembled the washer tank and replaced the pump, you can also refit the front with the bumper.

You will see on the dashboard that it indicates low washer fluid because the tank is empty.


Updated on 10 September 2026 by ScegliAuto


Related tutorials

How to Remove the AdBlue Warning Light on a Renault Megane?
How to Remove the AdBlue Warning Light on a Renault Megane?
Renault Megane (2015-2023 / Megane IV, Megane 4) If the AdBlue warning light has illuminated on the dashboard of your Renault Megane, it means that the fluid level in the emissions system is too low…
How to Check the Engine Oil Level in the Renault Megane
How to Check the Engine Oil Level in the Renault Megane
Renault Megane (2008-2015 / Megane III, Megane 3) In today's video, learn how to check if the engine oil level is correct in the Renault Megane. First, start your vehicle. When you turn the ignition …
How to Replace the Windscreen Washer Pump on a Renault Megane 2
How to Replace the Windscreen Washer Pump on a Renault Megane 2
Renault Megane (2002-2010 / Megane 2) If activating the windscreen wiper lever does not release fluid from the sprayers, it means the pump installed at the base of the washer fluid reserv…

Other guides you may be interested in

    Frequently Asked Questions

    • Megane 2008-2015 - Where is the internal temperature sensor located in the Renault Megane? Read answer

How to Remove the Rear Seat of a Hyundai Tucson?

To remove the rear seat of a Hyundai Tucson, follow these steps. Start by moving the front seats to their most forward position to gain space. Next, locate the release lever on the underside of the rear seat, near the floor. Press this lever down while pulling the seat upwards to unlock it from the anchor pins. Once unlocked, tilt the seat upwards and forwards to remove it from its position. Repeat this process for both sides of the rear seat. Be careful of any electrical cables or components that may be connected to the seat during removal. Once the rear seat is removed, the disassembly is complete.

Watch the video!


by ScegliAuto

More videos