Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Guide to replace the clutch of the Smart Fortwo

Model: Smart Smart 451 - Years 2007-2015
Part: Clutch

In today's video tutorial we will see how to remove and replace the clutch of the Smart Fortwo 451, following the instructions below. First we open the engine compartment and start by removing the air filter box; then we go to disconnect the drive shaft from the gearbox by unscrewing the pins of the arm. At this point we disconnect the exhaust manifold and unscrew the screws of the gearbox, in order to remove it; now we carry out the replacement of the clutch plates, as shown in the video. We apply the reverse procedure for reassembly!

Posted on 9 February 2022 by ScegliAuto

Video tutorial

Related tutorials

How does the clutch actuator of the Smart Fortwo work?
How does the clutch actuator of the Smart Fortwo work?
Smart (1998-2007 / 450) In this short and simple guide, we will see how the clutch actuator of the Smart Fortwo works. The clutch actuator of this car works electronically a…
How to install the clutch actuator on the Smart Fortwo 451
How to install the clutch actuator on the Smart Fortwo 451
Smart (2007-2015 / 451) In today's video tutorial we will see how to install the clutch actuator on the Smart Fortwo 451, following the instructions below. First of all we l…
How to relearn the clutch and transmission of the Smart Fortwo
How to relearn the clutch and transmission of the Smart Fortwo
Smart (1998-2007 / 450) Below we will see the main instructions that will allow us to carry out the relearning of the clutch and transmission of the Smart Fortwo. First of a…

Other guides you may be interested in

How to Replace the Thermostat on a Fiat Punto 2 Series 8v

When replacing the thermostat, it is advisable to drain the coolant system completely. The thermostat is located just above the gearbox, directly under the ignition coils. To facilitate the replacement, disconnect the intake duct hose and remove the coil pack. At this point, disconnect the connector from the thermostat and proceed to remove the corresponding fixing pins to replace it with the new one, ensuring to use a new gasket.

Watch the video!


by ScegliAuto

More videos