Do it yourself
Frequently asked questions about cars and motorcycles
  1. Car
  2. :
  3. Toyota
  4. :
  5. Rav 4
  6. : How to change the oil and replace the engine oil filter in a Toyota RAV 4

Toyota Rav 4 - Video tutorial

Model: Toyota Rav 4 MK 2, Xa20 - Years 2000-2006
Part: Oil filter
Operation: How to change the oil and replace the engine oil filter in a Toyota RAV 4

In this tutorial we will see how to change the engine oil and replace the filter in a Toyota RAV 4. First lift the bonnet of the car and fix it in a safe position using the special rod. At this point locate the oil cap and unscrew it; To change the oil, you will need to lift the car using special scaffolding in order to have access to the underside of the vehicle. Locate the oil pan bolt and with a 14 mm socket wrench unscrew it; let the used oil escape into an empty container. Then unscrew the filter cover cap and then the filter itself and proceed with extraction; let the remaining oil run out and then spray a cleaning spray to remove any residue. Now fit the new filter and screw the oil pan nut back on. Finally, use a funnel to pour in the new oil.


Posted on 15 December 2022 by ScegliAuto



Change the Toyota RAV 4 VVT-I engine oil and oil filter
Toyota Rav 4 (2006-2013 / Xa30, MK 3) Today we will see in this guide how to carry out the routine maintenance service, replacing the engine oil and the oil filter, of the Toyota RAV 4 VV
How to change the engine oil on a Toyota Rav 4
Toyota Rav 4 (2019-2024 / MK 5, Xa50) In this video tutorial today we are going to see how to replace the engine oil on a Toyota Rav 4. Raised the car we go to remove the protective plast
Changing the engine oil on a Toyota Rav 4
Toyota Rav 4 (2006-2013 / Xa30, MK 3) In this short video tutorial we are going to see how to change the engine oil on a third generation Toyota Rav 4. We start by lifting the car and fir

Other guides that may interest you

    Frequently Asked Questions

    • Rav 4 2013-2018 - Where is the Toyota RAV 4 oil filter located? Read Answer

Fiat Ducato 2.8 JTD gearbox oil replacement

Let's see in this guide the main steps to be able to change the transmission oil of the second series Fiat Ducato, with 2.8 JTD engine. First of all we lift the car and go to locate the gear oil vent bolt, which we find near the transmission; we use a hex wrench to unscrew it, letting it drain the old oil in a container for about ten minutes. At this point we open the bonnet and remove the air intake sleeve, so as to be able to access the gearbox oil filling hole; then we fill up to the maximum level!

Watch the video!


by ScegliAuto

More videos