|
Do it yourself
| |||
| ||||
How to check the speed sensor operation
Model: (Various brands) Various
This video is currently unavailable
Modern vehicles are equipped with a speed control sensor designed to measure the vehicle's speed and transfer data to the ECU. The sensor, which has replaced the mechanical measurement method, operates on an induction system characterised by fluctuating wave signals. Variations occur through rotation; its operating principle can be compared to that of the crankshaft position sensor, with signals transmitted via rectangular pulses with a duty cycle of 40/60% and switching from 0 to 5 volts. The speed sensor's operation involves calculating the time interval of the signals transmitted for every mile travelled, sending 6,000 pulses. The sensor calculates fuel delivery; releasing the accelerator pedal results in a significant reduction in fuel, allowing the engine to monitor fuel consumption. If this component fails, the ECU stops receiving necessary information, leading to excessive fuel consumption. The sensor also plays an important role in the correct shifting of the automatic gearbox. Common faults are due to circuit breakage and electrical failure. In this case, pay particular attention to the ends of the plastic connector and the areas near the exhaust manifold. Signs of malfunction include incorrect operation of the speedometer and engine instability, which manifests as increased fuel consumption with sudden power loss and engine stalling at idle. The driver can often test the sensor using a digital multimeter to determine the contact through which the pulses are transmitted. The positive probe connected to the sensor and the negative probe connected to the body will send signals to the speedometer providing information about the contacts; if there are no readings, the sensor is presumed faulty. To replace the device, disconnect the battery and unscrew the screws securing the sensor, then disconnect the connector and remove it. Installation follows the reverse procedure.
Posted on 20 November 2026 by ScegliAuto
Related tutorials
(Various brands) Various
The ABS speed sensor is located near the wheel hub, in front of a toothed ring called the tone ring. Before checking the speed sensor, ensure that th…
(Various brands) Various
Wheel speed sensors are part of the vehicle's ABS (Anti-lock Braking System), which distributes braking force to each wheel. These sensors are instal…
(Various brands) Various
The purpose of the crankshaft position sensor is expressed in its name: it sends the position of the crankshaft to the engine control unit (ECU). Tha…
ScegliAuto offers an extensive international collection of automotive tutorials available in 12 languages. Each guide combines instructional videos with original explanations written by experienced human editors, along with information about the car models covered.
Other guides you may be interested in
|
Frequently Asked QuestionsHow to Remove the Spare Wheel from the Citroen C4 Picasso
Follow these instructions to remove the spare wheel and replace it on the Citroen C4 Picasso. On this model, the spare wheel is located under the vehicle's floor; to lower it, simply unscrew the bolt to loosen the strap, then disconnect it from the spare wheel, as shown in the video. At this point, lift the vehicle and remove the wheel, securing the spare wheel or space-saver; tighten the bolts in a criss-cross pattern, finally placing the old wheel back under the vehicle's floor! by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.075
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy - About us VAT number: IT01247470535 |