Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Check the Operation of the Fuel Pump (Float)

Model: (Various brands) Various
Part: Fuel pump

In this video, you will see how to check the operational status of the electric fuel pump or the submerged float pump in the fuel tank of your vehicle, following these simple instructions. First, locate your fuel pump, which is usually found at the rear of the vehicle or under the rear seat; then disconnect the electrical connector of the pump and check with a multimeter if the power supply voltage reaches the connector. If the pump does not work, you can try tapping the fuel tank to trigger the pump operation; then proceed with the replacement!

Updated on 20 April 2026 by ScegliAuto

Video tutorial

Related tutorials

How Much Does It Cost to Replace the Internal Fuel Pump?
How Much Does It Cost to Replace the Internal Fuel Pump?
(Various brands) Various The cost of replacing the internal fuel pump can vary significantly depending on various factors such as the make, model of the vehicle, the location…
How to Replace the Fuel Pump in Your Car
How to Replace the Fuel Pump in Your Car
(Various brands) Various This video shows how to check the condition of your car's fuel pump and, if necessary, how to replace it. If your fuel pump needs replacing, you must…
Where is the Fuel Pump Fuse Located?
Where is the Fuel Pump Fuse Located?
(Various brands) Various The fuel pump protection fuse is usually found in the fuse box located in the engine compartment. This fuse controls the electrical supply. Since thi…

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos