Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Clutch from the Ape 50 in 5 Minutes

Model: (Various brands) Various
Part: Clutch

In this video tutorial, you can see how to remove the clutch from the Ape 50 in 5 minutes by following a few simple steps: no special tools are needed, just a 17mm spanner, a 10mm spanner, and a puller. Start by removing the bolts with the 10mm spanner; be careful with the lengths of the bolts, as the two longest bolts go at the back. After removing the bolts, you can open the clutch cover; if necessary, use a rubber mallet. Now, remove the thrust bearing with a screwdriver; then, using the 17mm spanner, unscrew the nut. Once the nut and washer are removed, take the puller and screw it into the clutch housing, hold the puller body steady, and tighten the bolt. Finally, remove the puller and pull out the clutch.

Updated on 4 June 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Clutch Cable on a Piaggio Ape 200
How to Replace the Clutch Cable on a Piaggio Ape 200
(Various brands) Various To replace the clutch cable on a Piaggio Ape 200, open the bonnet to locate the end of the cable connected to the clutch actuator. Disconnect this en…
Oil Change on Piaggio Ape
Oil Change on Piaggio Ape
(Various brands) Various The iconic Piaggio Ape is a vehicle (available in three or four wheels) capable of going anywhere with impressive carrying capacity: it has become a …
How to Replace the Battery of the Piaggio Ape Car 50
(Various brands) Various Replacing the battery of the Piaggio Ape Car 50 is not a complex task and takes only a few minutes to complete. Therefore, it can be easily done inde…

Other guides you may be interested in

How to Replace the Battery on a Honda Vision 110

To replace the battery on a Honda Vision 110, you need to remove the front fairing of the motorcycle, located directly under the front headlamp. To loosen this panel, unscrew the two screws found at its top, just below the handlebar. Once these screws are loosened, lever under the panel to detach it, gaining access to the battery underneath: this battery must be removed from its housing by unscrewing the fixing screws and disconnecting the power cables, replacing it with a new one.

Watch the video!


by ScegliAuto

More videos