Do it yourself
Frequently asked questions about cars and motorcycles
  1. Car
  2. :
  3. Volkswagen
  4. :
  5. Passat
  6. : How to remove the alternator of a Volkswagen Passat

Volkswagen Passat - Video tutorial

Model: Volkswagen Passat 3C, B6 - Years 2005-2010
Part: Alternator
Operation: How to remove the alternator of a Volkswagen Passat

Let's see how to remove and replace the alternator of a Volkswagen Passat. We pull the bar located at the bottom left of the dashboard and lift the bonnet putting it in safety, identify the battery of the power supply and disconnect the terminals (so as not to create problems). To remove the alternator of our car we have to remove the soundproofing panel of the engine; unscrew the pins with a socket wrench, being careful not to damage the cable winding membranes, unscrew all the fastening pins of the alternator, once the disassembly is finished, extract it from the engine compartment. We take the new replacement part and insert it into the suitable housing, screw in the locking pins, then tighten the side pins of the alternator. We check the right voltage with a tester by connecting it to the battery, check to do with the engine running to see if the value indicated by the tester increases. We reassemble the headlight with the respective pins and make sure the car works correctly.


Posted on 5 November 2023 by ScegliAuto



Where are the fuses located in the Volkswagen Passat?
Volkswagen Passat (2010-2014 / B7) On the Volkswagen Passat, the fuses are contained within the appropriate fuse boxes that are installed on the vehicle: in this car model it is possib
How to replace the water pump on a Volkswagen Passat
Volkswagen Passat (2010-2014 / B7) Before starting, we will have to open the front hood of our Volkswagen Passat. So let's start by disassembling and removing the service belt cover an
Where are the fuses located in the Volkswagen Passat?
Volkswagen Passat (2014-2023 / 3G, MK 8, B8) On the Volkswagen Passat, the fuses are contained inside the appropriate fuse boxes that are installed on the vehicle: in this type of car, it is pos

Other guides that may interest you

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos