Do it yourself
Frequently asked questions about cars and motorcycles

How to remove the headlight switch for the Volkswagen Polo

Model: Volkswagen Polo MK IV, Polo IV, Polo 4, MK 4, 9N - Years 2001-2009
Part: Checks and maintenance

Today we will explain how to remove the switch for the front headlights of the Volkswagen Polo car. To remove the switch, we need to rotate the knob in the center and push the switch inwards before removing it by pulling it outwards easily, being careful not to pull too hard to avoid damaging the connector. To completely remove the switch, we need to disconnect the connector. Now we can proceed with the replacement. For installation, we perform the reverse procedure; we connect the connector and then insert the switch into its slot.

Posted on 14 November 2025 by ScegliAuto

Video tutorial

Related tutorials

Volkswagen Polo (2009-2017 / Polo 5, Polo V, MK 5, MK V, 6R) In this video we see how to replace the headlight switch on a Volkswagen Polo 6R: it is a very common modification, because this component is often r…
Volkswagen Polo (2009-2017 / Polo 5, Polo V, MK 5, MK V, 6R) In this video we can see how to change the headlight switch of a Volkswagen Polo 6R (or Golf 4) from manual to automatic. It is a simple procedure. I…
Volkswagen Polo (2001-2009 / MK IV, Polo IV, Polo 4, MK 4, 9N) To remove the button for turning the headlights on and off on the Volkswagen Polo model 9n, you need to rotate the knob towards the centre at the mar…

    Frequently Asked Questions

    • Polo 2009-2017 - Where are the fuses located in the Volkswagen Polo? Read answer
    • Polo 2017-2025 - Message "Leave the vehicle only in position P" in the Volkswagen Polo, what does it mean? Read answer
    • Polo 2017-2025 - Where is the temperature sensor of the Volkswagen Polo located? Read answer

How to Repair the Key Spring of the Peugeot 207?

Over time, frequent use of the key's flip mechanism in the vehicle, dozens of times a day, inevitably leads to wear of the internal spring. As shown in this video, replacing the spring is quite simple and takes little time. After opening the casing halfway, first position the key, then the spring housing, and finally insert the spring into the previously mentioned housing. Close the casing by rotating it clockwise, ensuring all components fit perfectly, and test the key's flip mechanism.

Watch the video!


by ScegliAuto

More videos