Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Volkswagen
    3. :
  3. Polo
    4. : How to replace the headlight bulb on Volkswagen Polo mk5

Volkswagen Polo - Video tutorial

Model: Volkswagen Polo MK V, MK 5, Polo V, Polo 5, 6R - Years 2009-2017
Part: Headlight
Operation: How to replace the headlight bulb on Volkswagen Polo mk5

The guide shows how to replace the headlight bulbs of the 2014 Volkswagen Polo. The first step is to switch off the vehicle and secure it. After opening the hood and securing it, you can proceed with the disassembly of the two torx t30 screws; It is possible to disconnect the power cable of the light in question and, after applying a slight traction and disconnecting the two clips of the light body, it is possible to remove the piece. After removing the protective cover of the bulb to be replaced, simply turn the connector anticlockwise and remove it. At this point, after checking the model of the bulb to be replaced, you can continue with the replacement. By following the steps in reverse, you can put the light back in place. Check for proper operation of the lights before using the vehicle.


Posted on 6 February 2024 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • Polo 2001-2009 - How do you replace the front headlight of the Volkswagen Polo 8? Read Answer
    • Polo 2001-2009 - How much does the right headlight of a Volkswagen Polo cost? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos