Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Gear Selector Modification Kit

Model: Volkswagen Jetta A4, MK 4 - Years: 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005
Part: Shift knob

See other generations:
Video tutorial

If the gear lever tends to stick during gear changes, it is likely that there is play in the coupling between the pin and the plate that supports the gear cables: there is a modification kit that involves replacing the original plate with a steel one and replacing the cable fixing bushes with clamps.

Disconnect the gear cables from the plate and remove the plate itself, slide the eyelets off the gear cables and proceed with the installation of the new kit, inserting the cables into the appropriate clamps; before tightening the nuts, detach the gaiter of the gear lever, lift the soundproofing cover and insert a centring pin into the appropriate holes to keep the gear lever perfectly centred: at this point, tighten the nuts to secure the gear cables.


Updated on 14 February 2026 by ScegliAuto


Related tutorials

How to use Cruise Control in the Volkswagen Jetta?
How to use Cruise Control in the Volkswagen Jetta?
Volkswagen Jetta (2010-2018 / MK 6, A6) In this tutorial we can see how to use the Cruise Control in the Volkswagen Jetta, an extremely simple operation. This system should only be used on …
Instructions for Removing the Gear Knob
Instructions for Removing the Gear Knob
Volkswagen Jetta (2010-2018 / MK 6, A6) To remove the gear knob, start the engine and position the gear lever in neutral. Detach the chrome insert located at the centre of the knob by press…
Procedure to Install the GTA Kit
Procedure to Install the GTA Kit
Volkswagen Jetta (1998-2005 / A4, MK 4) In the following tutorial, the GTA kit is installed on a Volkswagen Jetta. To carry out this procedure, you need to extract the factory radio unit. S…

How to reset the tyre pressure warning light on the Kia Niro EV?

To reset the tyre pressure warning light on the Kia Niro EV, inflate the tyres until they reach the correct pressure value. This value is indicated on the sticker attached to the driver's door pillar. Once the tyres are inflated, turn on the instrument cluster to check that the warning light has completely disappeared from the display. If it is still present, you may need to drive for a few miles to ensure it disappears completely from the screen.

Watch the video!


by ScegliAuto

More videos