Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Volkswagen
    3. :
  3. Polo
    4. : How to reset the airbag warning light on Volkswagen Polo?

Volkswagen Polo - Video tutorial

Model: Volkswagen Polo MK V, MK 5, Polo V, Polo 5, 6R - Years 2009-2017
Part: Airbags
Operation: How to reset the airbag warning light on Volkswagen Polo?

To be able to reset the car airbag warning light, proceed as follows: use a diagnostic system which must be connected to the car's ODB2 port located under the dashboard on the left side of the steering wheel. Once the instrument has been connected to the car, we await recognition of the make and type of vehicle, then we await connection to the control unit and at that point it will be possible to read the list of errors present and, if necessary, cancel them. After that, it is possible to carry out a ignition test to verify that the warning light has actually gone out.


Posted on 14 December 2022 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • Polo 2009-2017 - What kind of error can the airbag of the Volkswagen Polo give? Read Answer
    • Polo 2009-2017 - When does the airbag light turn on in the Volkswagen Polo? Read Answer
    • Polo 2001-2009 - Where is the Volkswagen Polo 9N airbag control unit located? Read Answer
    • Polo 2017-2025 - What to do if the airbag light comes on in the Volkswagen Polo? Read Answer
    • Polo 2009-2017 - What does the "Airbag" light on a Volkswagen Polo mean? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos