Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Engine Oil and Filter Replacement

Model: Volkswagen Golf Golf 6, MK 6, 5K1, Golf VI - Years: 2008, 2009, 2010, 2011, 2012
Part: Engine oil

See other generations:
Video tutorial

If possible, position the vehicle on suitable car ramps to facilitate access to the oil sump; then place a container under the drain plug and unscrew it to drain the used oil. While the oil drains from the sump, locate the oil filter cartridge, which is situated in front of the sump, and replace it using a metal strap or chain wrench to unscrew it. Apply clean oil to the gasket of the new filter and screw it into place without exceeding the torque specification.

Finally, screw the plug back into the sump and fill the engine with clean oil until it reaches the correct level.


Updated on 15 February 2026 by ScegliAuto


Related tutorials

Replacing the Engine Oil Level Sensor on a Volkswagen Golf
Replacing the Engine Oil Level Sensor on a Volkswagen Golf
Volkswagen Golf (2003-2008 / Golf 5, MK 5, Golf V) In this brief guide, you will learn how to remove and replace the engine oil level sensor on a Volkswagen Golf. First, place the motorcycle on a stan…
How to Replace the Oil Filter, Engine Oil, and Air Filter on a VW Golf 7
How to Replace the Oil Filter, Engine Oil, and Air Filter on a VW Golf 7
Volkswagen Golf (2012-2019 / MK 7, Golf 7, Golf VII) The steps involved in the basic service of a Volkswagen Golf 7 are fairly simple to carry out yourself. The first step is to replace the engine oil a…
Engine Oil and Filter Replacement
Engine Oil and Filter Replacement
Volkswagen Golf (1997-2003 / Golf IV, Golf 4, MK 4) Lifting the vehicle on a ramp makes it easier to drain the oil and remove the filter, which is located just above the sump at the front of the engine…

Other guides you may be interested in

How to Reset the Tire Pressure Light on a MG ZS?

On the instrument cluster of the MG ZS, the tire pressure light that appears can be reset by inflating the tires to the correct pressure: this value will be indicated on the sticker attached to the driver's door pillar. Once the tires have been properly inflated, you can turn on the instrument cluster and navigate through the menu until you find the option that indicates tire pressure: if this screen shows the new values, the light will turn off; otherwise, you will need to drive for a few miles so that the sensors can read the new values and turn off the light afterward.

Watch the video!


by ScegliAuto

More videos