Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Volkswagen
    3. :
  3. Passat
    4. : How do you remove the Volkswagen Passat front bumper?

Volkswagen Passat - Video tutorial

Model: Volkswagen Passat B6, 3C - Years 2005-2010
Part: Front bumper
Operation: How do you remove the Volkswagen Passat front bumper?

In order to remove the front bumper of the Volkswagen Passat, you must first remove the grille located in the central part of the bumper: this will be fixed by the screws located in its upper part and by the two located below it. Once all the screws have been loosened, you can remove the grille and proceed to undo all the screws holding the bumper: these will be found inside the front wheel arches and in the lower part of the bumper itself. Once all the screws have been loosened, the connectors can be disconnected by completely removing the bumper and replacing it with a new one.


Posted on 24 December 2022 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • Passat 2005-2010 - How much does it cost to change the front bumper of the Volkswagen Passat? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos