Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Volkswagen
    3. :
  3. Polo
    4. : How to replace the ignition coil on a Volkswagen Polo IV

Volkswagen Polo - Video tutorial

Model: Volkswagen Polo Polo IV, MK 4, 9N, Polo 4, MK IV - Years 2001-2009
Part: Coil
Operation: How to replace the ignition coil on a Volkswagen Polo IV

Let's see how to replace the coil on a Volkswagen Polo IV. Disconnect the oil pan breather hose and lift off the crankcase hose. Undo the screws on the engine cover. Using a T30 torx wrench, remove the engine cover, then loosen the ignition coil connector locking clips. With a flat screwdriver, pry up the ignition coil. Using a coil puller, remove the ignition coil from the spark plug housing, then disassemble the connector. The tip of the coil should be treated with high temperature grease. To protect the contacts from corrosion, apply a small amount of dielectric paste (silicone grease) to the connector. Then connect the ignition coil connector, then install it in the spark plug housing: You must hear a "click" for it to be securely installed, then close the connector. Now we can reassemble the engine cover and fix it with the Torx T30 key. reconnect the oil sump breather pipe and the job is finished.


Posted on 10 April 2023 by ScegliAuto

Other guides that may interest you

How to reset the tire pressure warning light on Dacia Sandero?

Let's see below how it is possible to reset the low tire pressure signal on the car: first of all it is necessary to check the correct tire pressure by comparing it with the pressures reported in the use and maintenance manual. After that, turn on the ignition and locate the command on the right side of the steering wheel at the top that allows you to access the on-board computer menu, then select the car symbol, after which select the "up arrow" command up to that the indication "tire pressure" appears on the display. At that point, press the "Ok" control on the steering wheel and keep it pressed to reset the signal.

Watch the video!


by ScegliAuto

More videos