Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Volkswagen
    3. :
  3. Polo
    4. : How do you remove the Volkswagen Polo steering wheel airbag?

Volkswagen Polo - Video tutorial

Model: Volkswagen Polo Polo V, MK V, 6R, Polo 5, MK 5 - Years 2009-2017
Part: Airbags
Operation: How do you remove the Volkswagen Polo steering wheel airbag?

In order to replace the Volkswagen Polo steering wheel airbag, you need to turn the steering wheel first to the right and then to the left, so that you can release the two side pins at the rear of the steering wheel. To release them it will be necessary to use an object such as a screwdriver: once released, the airbag can be extracted from its housing in the center of the steering wheel, in order to disconnect the connectors in its internal part. Once these connectors have been detached, it will be possible to connect them to the new airbag, which must be fitted into its seat using the internal clips.


Posted on 14 April 2023 by ScegliAuto

This video is currently unavailable

    Frequently Asked Questions

    • Polo 2009-2017 - What kind of error can the airbag of the Volkswagen Polo give? Read Answer
    • Polo 2009-2017 - When does the airbag light turn on in the Volkswagen Polo? Read Answer
    • Polo 2001-2009 - Where is the Volkswagen Polo 9N airbag control unit located? Read Answer
    • Polo 2017-2025 - What to do if the airbag light comes on in the Volkswagen Polo? Read Answer
    • Polo 2009-2017 - What does the "Airbag" light on a Volkswagen Polo mean? Read Answer

How do you adjust the clutch cable on the Kia Picanto?

To be able to adjust the clutch cable of the Kia Picanto you need to open the hood so that you have access to the components inside the engine compartment: in order to reach the cable you will need to remove some components on the right side, such as the battery and the air filter. Below them you will find the clutch cable, which will have to be adjusted by screwing or loosening the bolt placed at the end of the cable. This will make the pedal harder or softer; after the adjustment, it will be possible to assemble all the components by closing the hood.

Watch the video!


by ScegliAuto

More videos