Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Alfa Romeo
    3. :
  3. 159
    4. : How to replace oil and filter in Alfa Romeo 159

Alfa Romeo 159 - Video tutorial

Model: Alfa Romeo 159 MK 1 - Years 2005-2011
Part: Engine oil
Operation: How to replace oil and filter in Alfa Romeo 159

In today's video we see how to replace the engine oil and its filter in the Alfa Romeo 159. First we open the bonnet and then unscrew the oil cap. We lift the car onto the deck and place a collection container under the oil pan. Now unscrew the relative cap and let the engine oil drain completely. Now let's take out the oil filter, located inside the engine compartment. Once this is done, we can screw the drain plug back on and then proceed to replace the oil filter and then top up the engine oil, according to the established level.


Posted on 17 October 2022 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • 159 2005-2011 - Where is the oil filter located on the Alfa Romeo 159 1.9 jtdm? Read Answer
    • 159 2005-2011 - Where is the Alfa Romeo 159 oil sensor located? Read Answer
    • 159 2005-2011 - How many liters of oil are needed for the maintenance of the Alfa Romeo 159 1.9 jtdm? Read Answer
    • 159 2005-2011 - How many liters of engine oil go into the Alfa 159 JTDm? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos