Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Car Pump

Model: Audi A4 B7 - Years: 2004, 2005, 2006, 2007, 2008
Part: Pump

See other generations:
Video tutorial

Changing your car's pump can be slightly complicated, but with a bit of patience and good will, it can be done. Each step necessary to disassemble the pump requires utmost care to avoid damaging parts of the car. The pump is located at the front of the vehicle, under the hood.

You need to remove the cover that secures the belt by unscrewing the bolts. Then, remove the timing gear and finally the tensioner bearing.

At this point, you can extract the pump by removing the screws present. Before replacing the pump with the new one, it is advisable to clean the engine block of any debris.


Updated on 10 February 2026 by ScegliAuto


Related tutorials

Replacing the Water Pump
Replacing the Water Pump
Audi A4 (2004-2008 / B7) The water pump should be replaced when it is not functioning properly because if it leaks, the cooling system will not work well and can cause the en…
Fuel Pump Replacement on Audi A4
Fuel Pump Replacement on Audi A4
Audi A4 (2000-2004 / B6) How to replace the fuel pump on an Audi A4? Let's go through the disassembly for replacement. Disconnect the battery cables for safety, then remove t…
Replacing the AdBlue Pump on the Audi A4
Replacing the AdBlue Pump on the Audi A4
Audi A4 (2007-2016 / B8) Let's go through the procedure to remove and replace the AdBlue pump (similar to the fuel pump) for emissions control on the Audi A4. First, lift the…

Other guides you may be interested in

How to Remove the Rear Seat of a Hyundai Tucson?

To remove the rear seat of a Hyundai Tucson, follow these steps. Start by moving the front seats to their most forward position to gain space. Next, locate the release lever on the underside of the rear seat, near the floor. Press this lever down while pulling the seat upwards to unlock it from the anchor pins. Once unlocked, tilt the seat upwards and forwards to remove it from its position. Repeat this process for both sides of the rear seat. Be careful of any electrical cables or components that may be connected to the seat during removal. Once the rear seat is removed, the disassembly is complete.

Watch the video!


by ScegliAuto

More videos