Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Ignition Switch on the Audi A4

Model: Audi A4 B8 - Years 2007-2016
Part: Key

In this video, you will see how to remove and replace the ignition switch on the Audi A4. First, get into the vehicle and start by removing the plastic cover behind the steering wheel, prying it off from the sides; then remove the small cover of the ignition switch and unscrew the fastening screw to take it out, disconnecting the electrical connector located at the back, as illustrated in the video. At this point, you can replace the ignition switch if necessary; all that’s left is to reassemble everything!

Updated on 14 June 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Ignition Switch on an Audi A4
How to Replace the Ignition Switch on an Audi A4
Audi A4 (2000-2004 / B6) Before you begin, sit in the driver's seat of your Audi A4. Start by removing the airbag; simply unscrew the mounting screws and disconnect the elect…
Replace the Ignition Key Battery of the Audi A4
Replace the Ignition Key Battery of the Audi A4
Audi A4 (2014-2024 / B9) Replacing the ignition key battery of the Audi is a very simple task that takes no more than 5 minutes. As the video shows: by pressing the sides of …
Instructions for Removing the Ignition Cylinder on Audi A4 B6
Audi A4 (2000-2004 / B6) In this video tutorial, you will see the main instructions for removing and replacing the ignition cylinder of an Audi A4 B6. First, get inside the c…

Other guides you may be interested in

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos