Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. BMW
    3. :
  3. Serie 3
    4. : How to disassemble and replace the water pump on a BMW 3 series

BMW Serie 3 - Video tutorial

Model: BMW Serie 3 E92, E91, E90 - Years 2005-2013
Part: Pump
Operation: How to disassemble and replace the water pump on a BMW 3 series

Let's see how to remove and replace the water pump on a BMW 3 Series. We lift the car on a column bridge and remove the engine guard placed under the car (if necessary), then disconnect the hose connected to the radiator. With a fixed wrench we go to loosen the belt tensioner roller and remove the belt from its seat. With a socket wrench we go to unscrew the tightening pin of the belt tensioner roller, remove the water pump as in the video. We assemble the new water pump, the belt tensioner and the belt itself, we tighten everything with the socket wrench. Finally we assemble the locking pins of the stone guard and refit the rim with the rubber on the car.


Posted on 31 October 2023 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • Serie 3 1990-2001 - What is the cost of the water pump on the 1992 BMW 320i? Read Answer
    • Serie 3 1990-2001 - How much does the water pump cost on the 1992 BMW 320i? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos