Do it yourself
Frequently asked questions about cars and motorcycles

How to Reset the Adaptive Headlight Indicator on a BMW 3 Series

Model: BMW Serie 3 E91, E90, E92 - Years 2005-2013
Part: Warning light – error code

Follow these steps to reset the adaptive headlight indicator on a BMW 3 Series. This operation is very simple. Enter the vehicle, turn on the ignition, and check if the warning light is on. Press the fixed button located near the speedometer, then scroll through the menu using the knob on the left above the control lever until you find the maintenance message. Select the desired maintenance and confirm by pressing the button on the left. Turn off the ignition after completing the service reset. Always remember to perform vehicle service modifications with the engine off.

Updated on 13 March 2026 by ScegliAuto

Video tutorial

Related tutorials

BMW Serie 3 (2005-2013 / E91, E90, E92) .. In this video, see how to reset the adaptive headlight indicator on a BMW 3 Series. This operation is very simple. Enter.. …
BMW Serie 3 (2005-2013 / E91, E90, E92) Learn how to perform the service reset on a BMW 3 Series. To reset the maintenance light: turn on the vehicle's ignition, use the button located to t…
BMW Serie 3 (2012-2019 / F30, F31) To reset the brake wear light on a BMW 3 Series, first replace the brake pads. Then, insert the ignition key into the ignition switch and turn it on.…

Other guides you may be interested in

    Frequently Asked Questions

    • Serie 3 2012-2019 - What does the BMW 3 Series F30 blue battery light mean? Read answer
    • Serie 3 2005-2013 - What does the check engine light mean on the BMW 3 Series E90? Read answer
    • Serie 3 1998-2006 - What does the EML light indicate in the BMW 3 Series? Read answer

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos