Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Start Button on BMW 3

Model: BMW Serie 3 E91, E90, E92 - Years 2005-2013
Part: Checks and maintenance

Is the ignition button faulty? Let's see how to change it on BMW 3. Use a plastic trim tool to remove the dashboard trim (where the air vents are located). Next, use a screwdriver to disconnect the power connector attached to the ignition button. Remove the ignition button from the plastic trim you just took off. Finally, install the new ignition button onto the previously removed plastic trim. Test the button's proper functioning by starting the engine.

Updated on 15 March 2026 by ScegliAuto

Video tutorial

Related tutorials

Replace the Timing Chain on a BMW 320 TDI
Replace the Timing Chain on a BMW 320 TDI
BMW Serie 3 (2012-2019 / F30, F31) A tutorial on how to replace the timing chain on a BMW 320 F30 is always very interesting. While changing the timing belt is a complex job, replacing…
Fuse Replacement on BMW 3 Series
BMW Serie 3 (2012-2019 / F30, F31) Let's see how to remove the fuses on a BMW 3 Series. Lift the hood of the engine compartment and locate the access panel on the left side. Remove the…
Replacing the Air Filter on a BMW 3 Series
Replacing the Air Filter on a BMW 3 Series
BMW Serie 3 (1998-2006 / E46) Replacing the air filter on a BMW 3 Series? Open the hood and let's see how to replace the filter. Locate the air filter housing on the right side of…

Other guides you may be interested in

    Frequently Asked Questions

    • Serie 3 2012-2019 - How much does a service cost for the BMW 3 Series? Read answer
    • Serie 3 2005-2013 - Why is the on-board computer of the BMW 3 Series slow to start up? Read answer

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos