Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Change the Transmission Fluid on a BMW X3 E83

Model: BMW X3 MK 1, E83 - Years 2003-2010
Part: Transmission fluid

In this guide, discover how to perform maintenance and change the transmission fluid on a BMW X3 E83, first generation. First, lift the vehicle and start by unscrewing the transmission fluid drain plug located on the top of the oil pan, as shown in the video; then let the fluid drain into a container for about ten minutes. At this point, remove and clean the oil pan, then replace the gasket; all that's left is to reassemble everything and add the new fluid, following the video to the end!

Updated on 19 April 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing the Transfer Case on the BMW X3 E83
Replacing the Transfer Case on the BMW X3 E83
BMW X3 (2003-2010 / MK 1, E83) In today's tutorial video, you will see the main instructions for removing and replacing the transfer case on the BMW X3 E83. First, lift the vehicle…
Resetting the Oil Change Light on a BMW X3 E83
Resetting the Oil Change Light on a BMW X3 E83
BMW X3 (2003-2010 / MK 1, E83) Today, let’s see how to reset the oil change light on a BMW X3 E83. Start by inserting the ignition key into the vehicle, then press and hold the lef…
Check Oil Level and Reset Light on BMW X3 E83
Check Oil Level and Reset Light on BMW X3 E83
BMW X3 (2003-2010 / MK 1, E83) Let's see how to check the oil level on a BMW X3 and then reset the service light: the same procedure applies to the X6 of the same period. The oil c…

Other guides you may be interested in

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos