Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. BMW
    3. :
  3. Serie 3
    4. : How do you replace the headlight bulb on the BMW 3 Series?

BMW Serie 3 - Video tutorial

Model: BMW Serie 3 E92, E91, E90 - Years 2005-2013
Part: Headlight bulb
Operation: How do you replace the headlight bulb on the BMW 3 Series?

In order to replace the headlight bulb on the BMW 3 Series, it is necessary to loosen the screws that secure the panel located in the wheel arch housing of the wheel corresponding to the bulb to be replaced: once this small panel has been removed, it will be possible to detach the cover protection inside the headlight, which will allow you to have access to the internal bulb. This must be disconnected from the relative connector and removed from inside its seat: in this way it will be possible to check that everything is working correctly by closing the headlight again.


Posted on 17 May 2023 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • Serie 3 2005-2013 - What is the BMW 3 Series parking light bulb? Read Answer
    • Serie 3 2005-2013 - What are the position bulbs of the BMW E90? Read Answer
    • Serie 3 2005-2013 - How to remove the headlight bulb of a BMW 3 Series? Read Answer
    • Serie 3 1998-2006 - How to replace the headlight bulb on a BMW 3 Series? Read Answer
    • Serie 3 2005-2013 - Where is the position light in the BMW headlight? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos