Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. BMW
    3. :
  3. X5
    4. : Disassembly of the rear bench for access to the fuel pump

BMW X5 - Video tutorial

Model: BMW X5 E70 - Years 2007-2013
Part: Rear bench seat
Operation: Disassembly of the rear bench for access to the fuel pump

In the event of poor power supply to the engine, a problem could lie in the malfunctioning of the fuel pump. To access it, it is necessary to remove the four plastic protections of the seat starting from the bottom. Remove the two seats, paying attention to the hooks of the seat belts and move them away from the car. Lift off the noise protection cover and with a ratchet wrench remove the four nuts of the fuel pump housing cover. Gently lift the cover paying attention to the power cables. To extract the pump, remove the supply pipe, disconnect the connector and unscrew the head screws on the edge of the pump.


Posted on 23 June 2023 by ScegliAuto



How to replace the fuel pump of a BMW X5
BMW X5 (1999-2006 / E53) How to replace the fuel pump of a BMW X5? To begin we disconnect the battery cables, then, we remove the seats of the rear seats of the car (the pump
How do you open the fuel door of the BMW X5?
BMW X5 (2019-2024 / G18, G05) On the BMW X5, in order to open the fuel door, you will need to press the appropriate button located inside the cabin, on the lower left side of the
How do you open the fuel door of the BMW X5?
BMW X5 (2019-2024 / G18, G05) To open the fuel door of the BMW X5, it is not necessary to press any unlock button from inside the cabin, but simply leave the key in its slot: this

Other guides that may interest you

Fiat Ducato 2.8 JTD gearbox oil replacement

Let's see in this guide the main steps to be able to change the transmission oil of the second series Fiat Ducato, with 2.8 JTD engine. First of all we lift the car and go to locate the gear oil vent bolt, which we find near the transmission; we use a hex wrench to unscrew it, letting it drain the old oil in a container for about ten minutes. At this point we open the bonnet and remove the air intake sleeve, so as to be able to access the gearbox oil filling hole; then we fill up to the maximum level!

Watch the video!


by ScegliAuto

More videos