Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. BMW
    3. :
  3. Serie 3
    4. : How to change the diesel filter on the BMW 320d E90

BMW Serie 3 - Video tutorial

Model: BMW Serie 3 E92, E91, E90 - Years 2005-2013
Part: Diesel filter
Operation: How to change the diesel filter on the BMW 320d E90

The diesel filter of this type of vehicle is of the in-line type and is not located in the engine compartment but immediately under the floor of the car, near the right rear wheel (passenger side); to be able to replace it, it is therefore suggested to lift the car, intercept the filter seat, remove the protective cover, disconnect the ground cable for protection against eddy currents and the two diesel inlet and outlet pipes; then unscrew the fastening of the support clamp, remove the old filter and insert the new one, orienting it according to the direction of the fuel flow indicated by the arrow printed on the filter itself.


Posted on 14 September 2023 by ScegliAuto

This video is currently unavailable

Other guides that may interest you

    Frequently Asked Questions

    • Serie 3 1998-2006 - Where is the diesel filter of a BMW 3 Series located? Read Answer
    • Serie 3 2005-2013 - Where is the BMW E91 diesel filter located? Read Answer
    • Serie 3 2005-2013 - Where is the diesel filter located in the BMW 320 year 2007? Read Answer
    • Serie 3 2005-2013 - Where is the diesel filter of the BMW 3 series touring? Read Answer
    • Serie 3 2005-2013 - Where is the diesel filter of the BMW 330? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos